Before Use; Cautions For Use; How To Use; Cleaning And Disinfection - Mopedia RS936 Manual De Instrucciones

Place the base on the bathtub and make sure that lateral mounts (C) are well put on the bath-
tub edge, minimun 2,5 cm.
Adjust the lateral mounts (D) and make sure the seat is stable (FIG. 2.)
To turn the bathchair use the lateral lever (F) near to the right armrest (FIG. 3).

8. BEFORE USE

• Check if the frame is damaged in order to guarantee a safe use for people and things
• Check the correct assembly of the device

9. CAUTIONS FOR USE

The manufacturer and distributor are not responsible for any responsibility for the
consequences of improper use of the product.
• Always help the patient with walking difficulties to position themselves on the seat
• Do not use with patients who exceed the maximum weight shown on the label placed on
the rear side of the backrest
• Avoid sudden movements during positioning
• Be careful on wet floors, on wet or slippery surfaces, it could make difficult the patient
positioning
• Do not store the product outside. Periodically check the stability of the product and the
correct fastening screws and the status of protections rubber
• In case of doubt for the use, the adjustment or the maintenance of the product, please
contact your dealer
Do not exceed the maximum load capacity for any reason!

10. HOW TO USE

• Place the seat in the tub and tighten the stoppers to make it stable
• Place the handle on the side opposite to the point of access to the tub
• If necessary help the patient to position on the seat
• Use the handle as an aid to move and position themselves correctly in the seat
• Turn the bathchair in front of the patient.
• Help patient to take correct place on the seat.
• Turn again the bathchair to put the patient in the bathtub.

11. CLEANING AND DISINFECTION

11.1 Cleaning

To clean the aid and the structure use a solution of alcohol and neutral soap (in equal parts)
mixed with water. Do not use abrasive substances, acids, alcohol, chlorine-based cleaners,
disinfectants and acetone when cleaning, because these substances cause the abrasion of the
plastic surfaces and rusting of metal surfaces.
The manufacture company cannot be held responsible for the damage that is caused by using
materials that could damage the product surface or corrosive chemicals during cleaning.
D
Fig.2
F
Fig.3
5