Festo 8129208 Instrucciones De Utilizacion página 16

Single-Phase Energy Measurement Box – Operating Instructions
16
• Setting up pneumatic circuits
– Connect the components with plastic tubing with an outside diameter of 4 or
6 mm.
– Push the pneumatic tubing into the push-in connector as far as it will go.
• Dismantling pneumatic circuits
– Switch off the compressed air supply before dismantling the circuit.
– Press the blue release ring down so that the tubing can be pulled out.
•
Noise due to escaping compressed air
– Noise caused by escaping compressed air may damage your hearing. Reduce
noise by using mufflers, or wear hearing protection if noise cannot be avoided.
– All of the exhaust ports of the components included in the equipment set are
equipped with mufflers. Do not remove these mufflers.
CAUTION
© Festo Didactic 8130877