Reer BabyCam XL Instrucciones De Uso página 25

Display
1. If the parent unit status light (15) starts flashing green, the built-in
battery is empty. This means the display needs to be recharged.
2. Adjust the volume using the Volume Control key (27). The volume is
displayed on the screen in the form of a bar chart. To mute the speaker,
press and hold the key to decrease the volume until the
ars. To cancel muting, press and hold the key to increase the volume
until it reaches the desired level.
3. To move the camera within the movement radius, use the arrow keys.
Please note that only one key can be pressed at a time.
4. To be able to talk to your baby, use the intercom function:
a. Press and hold the intercom button (14). As long as the icon
Camera Screen Alarm Lullaby Setting Tracking Light Zoom
2x appears on the display, you can speak in the direction of the
microphone on the bottom of the unit.
b. Now you can speak towards the microphone on the bottom of
the unit
c. Your voice will now be transmitted to the camera's speaker. You
can adjust the volume via the menu.
d. To hear your baby again, exit the intercom mode by releasing the
button intercom button (14). The microphone is then deactivated
and you can hear your baby through the speaker again.
5. If required, the display unit can also be placed on a flat surface (table
or similar). To do this, fold out the stand on the back. To increase the
range of the unit, you can fold out the antenna on the rear side.
6. Press the button
select the desired sub-item by navigating with the arrow keys. Pres-
sing the confirmation key (4) confirms the selection and goes to the
sub-item. Press the button
exit the menu.
briefly (21) to enter the main menu. You can
to return to the previous menu item or
icon appe-