Bobike one maxi Instrucciones De Uso página 6

Silla infantil para bicicleta
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

03. ASSEMBLY INSTRUCTIONS
EN
FITTING THE CARRIER ON THE BICYCLE
4
K1
Tighten the screws, with the key (H6), so that the frame
holder (K) is secured but not fully tightened so that, if
necessary, you can adjust the height later. However, note
that it should be tight to make it easier to complete the
next step. You need to tighten the 4 screws diagonally
and in 2 stages.
6
N
10cm
max
Center and adjust the metallic mounting bar (N) at a
height above the rear wheel, so that later, when you add
the weight of the child, the child carrier (A) does not
touch the wheel. Note that the metallic support bar (N)
should be positioned at a maximum of 3.94 in/ 10cm
away from the wheel. Never use the metallic support bar
(N) to carry other loads than this child seat, as indicated in
this manual.
K
H6
K
5
N
Place the edges of the metallic support bar (N) at the
holes of the frame holder (K) until you hear a click
indicating the lock, and until the release button (K3) shall
be level with the exterior of the hose frame holder (K).
7
H
To remove the rack attachment system (H) of the child
carrier you have to open the carrier mounting brackets
(L), pressing one of the brackets, pressing down the
button and pulling out. With the other hand you have to
pull out the rack attachment system (H), and finally press
and pull the other side bracket (L) to completely remove
the rack attachment system (H).
6
K
K3
L

Publicidad

Tabla de contenido
loading

Productos relacionados para Bobike one maxi

Tabla de contenido