Descargar Imprimir esta página

AirKing Professional Serie Manual De Operación página 2

Ocultar thumbs Ver también para Professional Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

9.25"
or
19.25"
Top of Hood Canopy
Figure 2
2.
Mark the location for the wall anchors that will hold the bracket onto the
wall. Drill holes (2 for each bracket) into the wall and install the included
wall anchors into holes. Secure the brackets into place with the provided
screws (Figure 3).
Wall Anchor
Figure 3
3.
Place the soffit in place on top of the hood canopy and line up the holes
in the hood canopy with the screw studs of the soffit.
4.
From inside the hood, using the included fasteners, secure the soffit to the
hood. Do not fully tighten the fasteners at this point (Figure 4).
Figure 4
5.
Line up the side holes of the soffit with the screw studs of the brackets and
using the included fasteners, secure the soffit to the brackets (Figure 4).
6.
Fully tighten all fasteners and make sure the soffit is firmly in place.
SECTION 3
Installation With Cabinets
NOTE: If multiple soffits are required for your installation, they must be connected
together, before being installed to the hood and wall.
NOTE: Any protective plastic adhered to the soffit should be remove before
installation of soffit between cabinets.
1.
Place the soffit in place on top of the hood canopy and line up the holes
in the hood canopy with the screw studs of the soffit.
2.
From inside the hood, using the included fasteners, secure the soffit to the
hood and fully tighten the fasteners (Figure 5).
111597003 New 3-07
Soffit
Brackets
Bracket
Screw
Soffit
Fastener
Hood
Figure 5
3.
Confirm that the soffit is seated in place securely and is flush against the
back wall. From inside the side cabinets, drill a small pilot hole in the upper
corner of the cabinet towards the rear of the cabinet through the cabinet
side and soffit. Install a sheet metal screw (not included) through the
cabinet and soffit. DO NOT over tighten the screw. This will prevent the
soffit from shifting or possibly coming loose and vibrating (Figure 6).
Screw
Figure 6
SECTION 4
Finishing the Installation
1.
Refer to the hood instruction manual to complete the installation, for
maintenance, and before restoring power.
2.
The soffit is covered under the range hood's warranty.
www.airkinglimited.com
Soffit
Fastener
Hood
Wall
Soffit
Cabinet
Screw
2 of 8

Publicidad

loading