IRIS RC8221 Manual Del Usuario página 4

RC8221 Iris
™
Camera
5. Privacy Button
6. WPS Button
7. Reset Button
8. Power LED
On (Green) - Power on.
Off - No power.
9. Network LED
On (Green) - Network (Wireless or LAN) connection is available.
Off - Wireless or LAN is not connected or camera is not sending/receiving
Blinking (Green) - Data is being transmitted or received via the LAN or
Enables/disables the camera's privacy features. When on, the camera will
not transmit images.
The WPS button on the device (and on other wireless devices) is used
to perform the WPS function that easily creates an encryption-secured
wireless connection automatically.
NOTE: Wireless security is configured during the Iris™ pairing process
(using the LAN cable). Please visit http://www.lowes.com/iris to learn more
about pairing your camera with Iris™.
This button is recessed; you need a pin or paper clip to depress it. It can be
activated at any time the camera is in the "ready" mode.
When pressed and held over 10 seconds, the settings of Network camera
will be set to their default values.
NOTE: After this procedure is completed, the Power LED will blink three
times to confirm that the reset was completed successfully.
WARNING: Before restoring the camera to its factory defaults, make
sure that you remove it from your Iris™ device list first. Please visit
lowes.com/iris to learn more about removing devices from Iris™.
Blinking - The Power LED will blink during start up. This may take up to 30
seconds.
data.
Wireless connection.
3