Installation Instructions - Pleasant Hearth L32-50 Manual Del Usario

INSTALLATION INSTRUCTIONS

NOTE: The manufacturer assumes absolutely no responsibility for injuries and damages that may
occur due to improper installation or handling. The appliance should not be installed until all wet
plastering and/or drywall sanding and wall painting has been completed. Do not block the ventilation
holes of the appliance. The wall onto which the appliance is installed must be flat. Install only on a
vertical surface. Avoid sloped surfaces. Installation onto anything other than a vertical wall may result
in fire, damage or injury.
DO NOT connect the appliance to the electric
1.
supply at this stage. Remove the single socket
screw from the middle of base panel of the heater
body (B) using a 3/16 in. (5 mm) hexagon key, then
remove the wall plate (C). After having selected the
final mounting position of the appliance, taking into
account the size and clearance requirements, the
electrical connection, and the strength of the wall,
the wall plate (C) may be secured to the wall.
CAUTION - The wall where the appliance is to
be installed must be capable of long-term support of
the total load of the appliance.
2. If the appliance is to be mounted on an inside brick
or solid masonry wall, then the wall plugs (BB) and
screws (AA) provided should be used. Wall plugs
(BB) are not necessary when mounting on a drywall
or plaster wall. However, screws (AA) should be
installed into a wooden stud in at least two positions
vertically. If this is not possible, then the wall should
be strengthened with additional studs or cross
members.
If there is no alternative to mounting directly on wall-
board, then wallboard anchors will be required (not
included). These should be metal, not plastic, and the
type indicated in Fig. 2.
3. Using a level to check correct horizontal alignment,
hold the wall plate (C) in the desired position and
use a pencil to mark the position of the mounting
holes on the wall. Remove the wall plate (C) from
the wall. For masonry, drill four holes using a 5/16
in. (8.0 mm) masonry bit to a depth of 1-1/2 in.
(43 mm) and insert the included wall plugs (BB).
For wallboard, drill four holes and insert wallboard
anchors (not included). Make sure the plugs or
anchors are flush to the wall. If installing directly
into studs, drill holes using a 1/8 in. (3.175 mm)
Continued on next page
1
B
2
3
9
C
socket screw
C