Conceptronic CBTHS2 Manual Del Usuario página 13

ENGLISH
Connect with a PC or PDA
You are allowed to connect the Earbridge with a Bluetooth enabled PC or PDA that has
support for the Bluetooth Audio Gateway profile.
Please refer to the user manual of your Bluetooth enabled PC or PDA for a setup information.
Low Battery
When the red indicator starts to flash, it indicates that the Headset is running low on battery.
Charge the Headset for 2 hours until the red indicator turns off.
B: Important Information
Trouble Shooting
•
The red LED indicator flashes.
It indicates that the Earbridge Headset is running low on battery. Charge the
Headset for 2 hours until the red LED indicator turns off.
•
The Conceptronic Earbridge cannot be activated after being charged for 20
minutes.
To activate the Earbridge, it needs to charge the battery at least for 40 minutes.
However, it is highly recommended to fully charge the battery before use.
•
No indication of charging is shown.
For the Earbridge battery that is empty, or has not been used for a long time,
it may take a couple of minutes for the Headset indicator to show charging status
with a steady red light.
•
No sound contact between Conceptronic Earbridge and other devices.
Make sure that the two devices have been paired.
-
Make sure that the Earbridge is turned on.
-
- Make sure that the two devices are within a working range.
Make sure that your Mobile Phone is within signal strength.
-
Some Bluetooth mobile phones can support only one Bluetooth Headset.
-
Disconnection may happen when there is more than one Headset paired with your mobile
phone.