QualityCraft SOQC935-MBK Manual De Instrucciones

design forward living
IMPORTANT:
PLEASE NOTE WHEN YOU OPEN THE CARTON CAREFULLY CHECK THE UNIT
AND MAKE SURE THERE IS NO DAMAGE. IF YOU HAVE ANY PROBLEMS WITH
ASSEMBLING THE UNIT, WITH HOW THE VARIOUS FUNCTIONS WORK OR
WITH DAMAGE OR MISSING PARTS PLEASE CALL 1-800-459-4409 (EST)
IMMEDIATELY FOR SERVICE. NOTE: DO NOT RETURN UNIT TO THE STORE
BEFORE CALLING THE TOLL FREE NUMBER. DO NOT DISPOSE OF YOUR
CARTONS UNTIL YOU ARE COMPLETELY SATISFIED WITH YOUR NEW STOVE
HEATER.
NOTE: Light bulbs may become loose during shipping. If the flame effect is dim or does
not work, please check that light bulb or bulbs are finger tight in socket. See instructions
for replacing bulb or bulbs.
INSTRUCTION MANUAL
ATTENTION:
1) Find a location for the stove heater that is protected from direct sunlight.
2) Do not plug the unit into the power outlet before reading all instructions.
SAVE THESE INSTRUCTIONS FOR FUTURE USE.
IMPORTANT SAFETY INSTRUCTIONS
WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS
BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND INJURY
TO PERSONS, INCLUDING THE FOLLOWING:
1) Read all instructions before using this electric stove heater.
2) This electric stove heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. If provided, use handles when moving this heater.
Keep combustible materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 feet (0.9 m) away from the front of the unit
and keep them away from the sides and rear.
3) Extreme caution is necessary when any heater is used by or near children
or individuals with disabilities and whenever the stove is left operating and
unattended.
4) Always unplug stove when not in use.
5) Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Discard heater,
or return to authorized service facility for examination and/or repair.
6) Do not use outdoors.
7) This electric stove heater is not intended for use in bathrooms, laundry areas
and similar indoor locations. Never locate heater where it may fall into a
bathtub or other water container.
8) Do not run cord under carpeting. Do not cover cord with throw rugs, runners,
or similar coverings. Do not route cord under furniture or appliances. Arrange
cord away from traffic area and where it will not be tripped over.
9) To disconnect stove, turn controls to off, then remove plug from outlet.
10) Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
11) To prevent a possible fire, do not block air intakes or exhaust in any manner.
Do not use on soft surfaces, like a bed, where openings may become
blocked.
12) A heater has hot and arcing or sparking parts inside. Do not use it in areas
where gasoline, paint, or flammable liquids are used or stored.
ELECTRIC STOVE
HEATER
Model: SOQC935-MBK
13) Use this stove heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury to
persons.
14) Always plug heater directly into wall outlet / receptacle. Never use with an
extension cord or re-locatable power tap (outlet/ power strip).
15) Caution: Do not plug this product into a receptacle controlled by a wall switch
or dimmer.
16) When storing or transporting the unit and cord, keep in a dry place, free from
excessive vibration and store so as to avoid damage.
CAUTION:
IF YOU USE THIS HEATER IN CONJUNCTION WITH A THERMAL CONTROL, A
PROGRAM CONTROLLER, A TIMER OR ANY OTHER DEVICE THAT SWITCHES THE
HEATER ON AUTOMATICALLY, REMEMBER TO OBSERVE ALL SAFETY WARNINGS
AT ALL TIMES. THE STOVE HEATER HAS SAFETY OVERHEAT PROTECTION. IF THE
OVERHEAT PROTECTION TRIPS, SWITCH OFF ALL SWITCH BUTTONS AND WAIT
APPROXIMATELY 5 -10 MINUTES. IT SHOULD RESET AUTOMATICALLY ONCE THE
UNIT COOLS DOWN.
NOTE: The stove may emit a slight harmless odor when first turned on. This is caused by
activating the internal heater components for the first time and should not occur again.
A 15 AMP circuit is required to operate this heater. If the breaker trips when the heater
is used then you may need to move the heater to another location or unplug other
appliances that are on the same circuit. If you require an extension cord use one that is
rated at 1875 watts.
LEG ASSEMBLY:
Before using your unit, please install the leg as shown in diagram below:
After completely reading instructions, confirm that all controls on stove are in the OFF
position. Plug the unit into a 15 amp, 120 volt outlet.
1