Metra Electronics 95-9313B Instrucciones De Instalación página 9

7. Set the air box cover into place
and secure the right side with the
metal retaining clip removed in
step 1. Secure the left side with
the (1) #6 x 1/2" Phillips screw
supplied. (Figure G)
8. Metra recommends using tape
along the upper edge of the air box
cover where the cut was made.
Duct tape or A/C aluminum tape is
suggested. (Figure H)
Continue to kit assembly
Sub-dash airbox modifications
Screw
location
(Figure G)
95-9313B
Clip
location
(Figure H)
9
Tape the shaded area