Fulgor Milano FVCD 270 Manual De Montaje página 39

Assembly Instructions
TOPPING UP OF OIL AND PUMP ExHAUST FILTER REPLACEMENT
(IN CASE OF OIL SPILL IN TRANSIT)
If the appliance has been transported in a non-vertical position (e.g. on its back) or has been overturned
during installation, check the oil level in the pump through the inspection window (3) and also check
that the exhaust filter is free of oil.
Open the machine by unscrewing the two side screws of the same and overturning the casing by 45°.
Lock the machine in open position with the special
stick (A).
If necessary and top-up the pump using ORV40 oil
and replace the exhaust filter following the steps
below.
FVCD 270
MAx
MIN
A
6
3
4
1) Pump.
2) Oil top-up cap.
3) Oil level.
4) Oil drain cap.
5) Oil drain rubber cap.
6) Oil filter.
2
1
5
39