Power Source; Using The Stand - memorex MDF0738-BLK Guia Del Usuario

AC CONNECTION
Insert the small end of the AC adapter into
the DC 5V IN jack (located on the bottom of
this unit). Connect the other end to a wall
outlet having 120V AC, 60 Hz.
AC Adapter, DC 5V Z
NOTES:
• Remove both the DC plug and the AC-
IN plug to disconnect the AC adapter
when not in use, because this unit will
always be ON when the DC plug and the AC-IN plug are connected.
• Only use the supplied AC adapter which has the following specs: DC 5V Z
STAND (REAR OF UNIT)
To use the stand, place the stand's knob into the hole in the back of the
frame. Push the stand either to the left (for a vertical display) or to the
right (for a horizontal display) until the stand locks into place.

POWER SOURCE

USING THE STAND

4