Installation; How To Install - Kenmore 580.74107 Manual Del Propietário

INSTALLATION
Pick a location which will allow you to blow the cold
air into the area you want. Windows used for
installation must be strong enough to support the
weight of the air conditioner. Good installation with
special attention to the proper position of the unit
will lessen the chance that service will be needed.
When cooling more than one room, installation
location is very important. To cool your rooms, cold
air must be blown from the air conditioner in a
straight path.
HOW TO INSTALL
If the air conditioner is blocked by a storm
window frame, see step 19 on page 8 before
beginning to install.
O Remove the screws which fasten the cabinet at
both sides and at the back. Save side screws.
Discard back screws.
FIG. 3
_"_ Slide the unit of the cabinet the
out
by gripping
base pan handle and pull forward while bracing the
cabinet.
FIG. 4
_E_J Cut the FOAM SEAL (ITEM I) to fit the
underside of the window sash. Peel off the backing
and attach the FOAM SEAL as shown in Fig. 5.
FIG. 5
D Insert the side curtain (ITEM A) into the upper
guide and lower guide of the air conditioner. Fasten
the curtains to the unit with screws (ITEM E).
Upper guide
ITEM.E
6
_4J Open the window. Mark a line on center of the
window inner sill.
Carefully place the cabinet on the window inner sill
and align the center of cabinet front with the center
line marked in the window inner sill.
Window sill
FIG. 7
r_Pull the bottom window sash down behind the
upper guide until they meet.
NOTE: Do not pull the window sash down so tightly
that the movement of side curtain is restricted.
Window sash Upper guide
+?++2:+°
FIG. 8
H Loosely assemble the sill supports using the
parts in FIG. 9.
0 o0=oo
__'_ ITEM D ITEM B
iTEM C
FIG. 9
-6-