Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION REQUIREMENTS
Your air conditioner
will install into standard double hung
windows with actual clear opening widths of 22 to 36
inches (559mm to 914mm) (FIG. 1).
Lower sash must open sufficiently
to allow a clear
vertical
opening
of 13 inches
(331 mm). Side louvers
and the rear of the air conditioner
must have clear
air space to allow enough
airflow
through
the
condenser
for heat removal.
The rear of the unit
must be outdoors,
not inside
a building
or garage.
"
Sash
1 22 t e30"--I
I
1113" m'n inner sitll I _
Window
,,_'÷i'l;><- ,_
Offset
si,
_
Exterior
Interior watt "*",,_
i_
FIG. 1
-.
....
÷
ELECTRICAL
SERVICE
Check your available electrical service. The power
supply available must be the same as that shown
on the unit nameplate (found on right side of cabinet).
All models
are equipped
with a 3-prong
service
plug
to provide
proper
service
and safe positive
grounding.
Do not change
plug in any way.
Do not
use an adapter
plug. If your present
wall outlet
does
not match your
plug, call a qualified
electrician
to
make the necessary
corrections.
SAVE CARTON
and this OWNER'S
MANUAL
for
future
reference.
The carton
is the best way to store
unit during
winter or when not in use.
To avoid risk of personal injury, property damage,
or product damage due to the weight of this
device and sharp edges that may be exposed:
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• Carefully inspect location where air conditioner
will be installed. Be sure it will support the
weight of the unit over an extended period of
time.
• Handle air conditioner with care. Wear
protective gloves whenever lifting or carrying the
unit. AVOID the sharp metal fins of front and
rear coils.
• Make sure air conditioner does not fall during
installation.
INSTALLATION
HARDWARE
®
ITEM
NAME OF PARTS
Q'TY
A
SHORT SCREW
11
B
WOOD SCREW
5
C
L BRACKET
3
D
FOAM STRIP
1
E
FOAM SEAL
1
F
SIDE CURTAIN
2
G
DRAIN PIPE
1
H
SUPPORT BRACKET
1
REQUIRED TOOLS:
• Tight
Fitting
gloves
• Standard
screwdriver
• Phillips
screwdriver
• Pliers
• Sharp
knife
• 3/8-inch
open
end
wrench
or adjustable
wrench
• 1/4-inch
hex socket
and ratchet
• Tape measure
• Electric
drill
• 1/4-inch
drill bit
-5-
Publicidad
Capítulos
Tabla de contenido
