How To Operate - Continental Electric CE22841 Manual Del Usuario

Licuadora de mano
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SPECIAL NOTES ON CORD PLUG
This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of electric shock, the plug can fit into a polarized socket only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not modify the plug in any way

How to Operate

1. Plug power cord into 120 volt AC outlet.
2. Place blade-end of unit directly into included beaker or bottom of a tall plastic
container holding ingredients to be blended.
3. Your blender has LO and HI speeds for quick blending. Press the LO or HI switch
for continuous blending. Blending action stops when switch is released.
NOTE: During use, it is normal for a suction to be created at the bottom of the
container.
4. For a short "burst" of blending, quickly push and release the LO or HI switch.
5. After blending, unplug unit.
CAUTION: Do not use blender in saucepan directly on stovetop. Remove pan from
heat before blending. To avoid splatter, never lift blender out of hot ingredients while
motor is on.
How to Clean Your Hand Blender
1. For easy cleaning, place blade-end of unit under hot, running water immediately
after blending is completed.
2. Wipe motor-end of handle with a damp cloth or sponge.
3. The shaft, chopper bowl, blade, and beaker are all dishwasher safe. Do not put
the chopper cover in the dishwasher.
Tips
• For thorough blending, add liquid portion of recipe last (such as milk to ice cream
for a milk shake). Exception: When blending a powdered mix with a liquid, add
liquid first and then powder (such as milk for a diet drink or water for a soup mix).
• When processing bread, cracker and cookie crumbs or chopping nuts, use a
covered container.
• Cut all solids (cooked meats, vegetables and fruit) into approximately 1-inch
pieces before blending.
• Remember: The blender performs its tasks in seconds – not minutes. Stop blender
and check the consistency before contents become too fine or overblended.
• Do not overtax the motor with extra-heavy loads such as stiff dough, cream
cheese dips or butter.
• If blending action in container should stop during processing before mixture is
smooth, unplug unit and remove ingredients from blade with rubber spatula. Plug
in unit to complete blending.
• It may be necessary to stop blending action and remove blade-end from
ingredients and reinsert several times before mixture becomes smooth.
• To make beverages icy cold, add one ice cube at a time (up to 6) to an already

Publicidad

Tabla de contenido
loading

Tabla de contenido