HoMedics enviraScape WF-MN-MOON Manual De Instrucciones E Información De Garantía página 3

WF-MN-MOON_B_SP.qxd 2/20/06 5:23 PM Page 5
• The electrical cord of this product cannot be replaced. If it sustains
damage, you must stop using the appliance immediately and
return it to the HoMedics Service Center for examination and
repair. (See the warranty section for HoMedics address).
• Disconnect the appliance from the electrical outlet before putting
hands into water.
Assembly and Instructions for Use
1. Remove all contents from packaging and inspect to make sure
all components have been received (Fig. 1):
• Base with attached electrical cord and water pump
• Fountain top
• Polished river rocks
2. Wipe any dust off the interior and exterior of the base and top
and rinse river rocks under water.
3. Familiarize yourself with the pump. The pump speed is
controlled by the switch located at the front of the pump. The
speed is indicated by a plus (+) and minus (-) sign. To increase
the speed, move the switch slowly to the left in the direction of
the plus sign. You will hear a click as the switch moves to each
speed level. At its highest speed level, the switch will cease to
move any further. To decrease the pump speed, move the switch
to the right toward the minus sign. Similarly, at its lowest speed,
the switch will cease to move any further (Fig. 2).
Figure 1
FOUNTAIN TOP
FOUNTAIN PUMP
FOUNTAIN BASE
POWER CORD
4
Figure 2
4 stopping
points for
water flow
Figure 3
POWER CORD
CORD NOTCH
Figure 4
POLISHED ROCKS
NOTE: It is recommended the pump be set at its
highest speed during assembly and later adjusted
to a lower setting if desired. Be sure to unplug the
pump before adjusting the speed setting.
4. Place the fountain base on a sturdy, level surface
in the desired location, ensuring its electrical cord
will sufficiently reach an electrical outlet. Once
assembled, the fountain may be difficult to move
due to splashing. Once in the desired location,
lead the power cord attached to the base through
the notch at the bottom of the base to ensure the
base sits level without wobbling. Do NOT plug in
at this time (Fig. 3).
5. Add clean water to the base until the water level
is 1/2 - 3/4" below the rim.
6. Connect the PVC tube to the pump, adjust the
pump speed and place the fountain top on the
base (Fig. 4).
7. Place the fountain top onto the base and then
arrange the polished river rocks around the
fountain top. (Be sure not to place any rocks
inside the base of the fountain).
8. Plug the cord into a 120V household outlet. Once
plugged in, the fountain is turned on. The pump
must be unplugged to be turned off.
NOTE: If you can hear the pump gurgling or making
sounds, you have not added enough water to cover
(submerge) the pump.
9. It will be necessary to add water occasionally due
to evaporation.
NOTE: Always add water when fountain is "OFF"
to avoid overflow.
5