ARENDO 304397 Manual Del Usuario página 22

5. Commissioning and use
First proceed as described in Section "3 Initial commissioning". Lightly grease
the baking plates of the waffle maker on the inside. Connect the power cord to a
properly wired power socket. The POWER LED starts glowing
Before you start baking, wait till the appliance is preheated. The appliance is
preheated when the green "READY LED" starts glowing.
For hygienic reasons we advise you not to consume, but to dispose of the first
waffle baked used this appliance.
1. Open the lid using the handle.
2. Put the waffle batter in the centre of the lower baking plate.
3. Spread the batter evenly on the plate. We advise you to use a heat-resist-
ant spatula as a tool.
4. Close the appliance lid using the handle.
5. Select the desired browning using the degree of browning dial. The
following chapter (6. Adjusting the degree of browning) can be used for
assistance.
6. Once the waffle meet your requirements and the baking is finished, open
the appliance lid and remove the waffle from the appliance.
Caution! Please do not use metal objects to remove the waffle. This can damage
the non-stick coating!
7. Finally disconnect the plug from the mains socket.
22
English