Eaton Metalux RBSURF6 Instrucciones De Instalación página 3

A6. Unscrew and remove the long rail that is not
attached to the surface, as well as the L- brackets,
and retain for reuse. (Figure 6.)
Figure 6.
A7 . Use flexible metal conduit with 90-degree conduit
fittings to bring supply conductors into the wiring
compartment on the back of the fixture. Wire
according to instructions included with the fixture.
(Figure 7 .)
Figure 7.
A8. Slide the fixture completely into the channel
through the open side. (Figure 8.)
Figure 8.
Installation Instructions – 2RBSURF6 and 4RBSURF6
A9. Reinstall the floating long rail, L- brackets and
screws, and affix the included labels to the floating
long rail next to each screw. (Figures 9 and 10.)
N ote: Screws may strip if over torqued.
Floating Long Rail
Figure 9.
Floating Long Rail
Figure 10.
B. Instructions for Wall Mount, Horizontal
Orientation
B1. Follow steps A1 - A3 above to assemble box.
B2. Locate box on the wall and mark mounting holes.
It is recommended to mount the box such that the
N ote:
supply conductor junction box is located at one
end of the box. This will ensure there is enough
free space inside the box for excess flexible metal
conduit. (Figure 11.)
Supply Conductor
Junction Box
Bottom Rail
Figure 11.
EATON IB519115EN Installation instructions
3