Philips GC1900 Serie Manual Del Usario página 16

EnGlish
16
Problem
The light on
the handle
flashes
(specific types
only).
Water
droplets drip
on the fabric
during ironing.
Possible cause
The automatic
shut-off function
has been activated
(see chapter
'Features', section
'Automatic
shut-off ').
You have not
closed the cap of
the filling opening
properly.
The set
temperature is too
low for steam
ironing.
You have put an
additive in the
water tank.
Specific types only:
you have used the
steam boost
function at a setting
below 3.
Specific types only:
you have used the
steam boost
function too often
within a short
period.
Solution
Pick up the iron or move it
slightly to deactivate the
automatic shut-off function. The
automatic shut-off light goes out.
Press the cap until you hear a
click.
Set an ironing temperature that
is suitable for steam ironing (
2 to MAX). Put the iron on its
heel and wait until the
temperature light goes out
before you start ironing.
Rinse the water tank and do not
put any additive in the water
tank.
Set the temperature dial to a
setting between 3 and
MAX.
Put the iron on its heel or
continue ironing in horizontal
position and wait a while before
you use the steam boost
function again.