Selecting A Location; Operating The Unit - Twin-Star International TRESANTI DC997 Manual Del Usuario

Installation And Operation Instructions
1. Unpacking the Wine Cooler:
a. Your Wine Cooler comes fully assembled inside the corresponding wood cabinet
b. Unpack the unit at close proximity of its fi nal location to avoid damage while moving the unit.
c. Ensure that all packaging and printed materials are disposed of before operating the unit.
i. There is protective Styrofoam packaging located inside the back of the wood cabinet which must
be removed before operating the unit to ensure proper ventilation of the coolers.
ii. There is packaging located inside the cooler holding the wine racks which must be removed.
iii. A large plastic bag may cover this unit for protection. Please dispose of this large plastic bag
carefully. Do not discard in any area accessible to children. Plastic bags can be a suffocation hazard.

2. Selecting a Location:

a This unit is for Interior Home-Use only. To minimize the risk of rusting, leakage and insulation damage,
avoid placing the unit in a place where heavy moisture is present. Under no circumstances should you
apply water directly onto or into the unit.
b. Do not install this unit in any location that is not properly insulated or heated (such as a garage).
c. Select a suitable location for the unit on a hard, even surface away from direct sunlight or heat source
(ie. radiators, baseboard heaters, cooking appliances, etc.) and avoid placing the unit where there may be
electrical interference.
3. Installation :
a. Simply plug the unit into a suitable power outlet (115V ~ 60Hz 15A) with proper grounding. Then gently
push the wood cabinet against the selected wall.
b. Avoid the use of three plug adaptors and do not alter the plug under any circumstance.
c. Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is
necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug
and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance.
4. Venting:
a. The wine cooler is rated for built-in use. However, proper ventilation must still be maintained in order to
ensure the proper function and reliability of the unit.
b. There are vents and openings strategically located on the wood cabinet in order to ensure air fl ow.
Neither block-off these areas nor modify the cabinet under any circumstance.
c. Do not overfi ll your wine cooler for proper internal air circulation.

5. Operating the Unit:

a. Temperature adjustment:
i. The temperature inside the wine cooler can be adjusted between min. and max. settings using the
rotary switch located on the upper corners of each zone in the cooler casing.
ii. The actual cabinet temperature in a thermal electric unit is dependant on the ambient room
temperature. When the ambient temperature is below the set temperature the wine cooler will not
operate until the ambient temperature increases to higher than the set temperature.
b. Interior light:
i. There are lights located inside the wine cooler for your viewing convenience. Light switches will
activate the lights. Under normal operation it is best for the light to remain off.
DC997REV.3 www.tsicustomerservice.com
16
MP#GL