PNI PG600 Manual De Usuario página 8

Install the central unit
Move the bracket of the central unit to
it to the wall with screws. Install the siren body on the bracket and rotate it to
direction.
Install the door/window contact
• The gap between the sensor and magnet should be less than 10 mm.
• If remove the two parts from each other, and the LED on the sensor lights up, then
the sensor is working properly.
• If the two parts are close and the LED flashes rarely, it means that the battery is low.
Replace the battery.
• The maximum transmission distance is 80 meters. The presence of obstacles
reduces this distance. Carefully choose the location of the sensor installation.
8
(disarmed) direction, remove the bracket and fix
(armed)