Stroller Maintenance; Cleaning - Foundations LX3 Instrucciones De Montaje

To adjust brake cable length:
1.
Using an adjustable wrench, loosen the
Jam Nut on the runaway brake cable
adjustment sleeve (Fig. 5).
2.
Using an adjustable wrench,
turn the runaway brake cable
adjustment sleeve up to lift
brake lever higher or down
to lower brake.
3.
While holding runaway brake
cable adjustment sleeve, use
an adjustable wrench to tighten
jam nut.
4.
Repeat step 1 through 3 on opposite side of stroller.
NOTE: It is important that both sides are adjusted equally so
that the stroller will not turn when runaway brake is applied.
5.
Recheck runaway brake for proper operation, see "To Check For Proper
Operation Of Runaway Brake" section.
6.
If the stroller still does not stop immediately or turns when runaway
brake handle is released, repeat steps 1 through 5.
NOTE: If problems persist call Foundations
or assistance.
Cleaning seats, harness, armrests, arm bar and canopy:
1.
Surface wash only with mild solution of soap and water.
2.
Rinse with water to remove soap solution.
Cleaning Stroller:
1.
Surface wash stroller frame, plastic parts and fabric with mild solution of soap
and water. Wipe surfaces with water to remove soap solution.
2.
Wipe or air dry.
Brake Adjustments
Adjustment

Stroller Maintenance

19
Runaway
Cable
Adjustment
Sleeve
Runaway
Cable
Sleeve
Adjust
Lower
for replacement parts
®
Fig. 5
Jam
Nut
Adjust
Higher
Jam
Nut