Technical Specifications; User Interface - Onbone A002 Guia Del Usuario

• Do not replace detachable mains supply cords by inadequately rated cords.
• Risk of burns. Do not touch the Infrared heating element.
• Risk of ignition. Long splints: use only Onbone splints.
Do not try to fold unheated sheets yourself.
• Risk of ignition. When heating pre-padded Onbone products, ensure that
the padding material is heat resistant.
Cleaning
Unplug the device prior to cleaning. Wipe the device with a damp cloth. To clean
the device use a general purpose detergent, soap or diluted ethanol (70 vol-%).
Allow the device to dry prior to next use! Do not use abrasive cleaners. Remove
any residues gently with a microfibre cloth. Take care not to scratch the
cabinet surfaces.
Troubleshooting
Unplug the device and contact your sales person. Do not attempt to repair the
device by yourself!
Warranty, Service and Disposal
The device has a 1 year warranty. Please contact the retailer in the event of any
warranty issues. The device can be disposed as electrical waste in accordance
with local regulations.

Technical Specifications

Power Supply 230 V AC, 50 Hz
Output power 1500 W
Weight approximately 10 kg
User interface: ON/OFF indicator light, hot surfaces warning light,
programme switches.
Operating conditions: indoors, temperature range 5 – 40 °C, and at maximum
of 2000 m from sea level, and maximum relative humidity 80 % (31 ˚C) – 50% (40
˚C). Non-condensing. Power connection: Safety grounded IEC power supply
connector (C14). Internal protection: replaceable 8 AT (250 Vac) (slow blow)
glass tube fuse 5 x 20 mm, in both phase and neutral conductors. Programmat-
ic resetting overheating protection (100 °C). Non-resettable thermal protection
(128 °C). Safety class I. Enclosure class IP 21.
The product conforms to the following standards:
EN 61010-1 and IEC 61010-2-010.

User Interface

1. On/off indicator light
2. Orange hot surfaces warning light
3. Programme selection switches
1. 2.
3.