Kohler K-15135 Guia De Instalacion página 4

1-1/2" (38 mm) –
2-7/8" (73 mm)
Apply
plumbers
putty.
3. Install the Slip-Fit Spout
NOTE: The following instructions are for slip-fit spout installations
only. For threaded spout installations, go to the preceding section.
Remove the temporary nipple from the bath elbow.
Install a tube that extends 1-1/2" to 2-7/8" past the finished wall.
Use emery paper to remove any burrs and to smooth the edge of
the copper tubing.
Loosen the setscrew with a 5/32" hex wrench.
Slide the spout onto the copper tubing, push the spout base
against the finished wall, and then carefully retighten the
setscrew. Do not overtighten the setscrew.
Remove all excess putty or sealant.
1011610-2-D
Slip-Fit Spouts
5/32"
4 Kohler Co.