HoMedics MicroDermabrasion FAC-300 Manual De Instrucciones Y Garantía página 3

MicroDermabrasion Complete System Features
• Rechargeable Resurfacing Tool
• 2 Tubes Unscented MicroDermabrasion Cream (2 oz ea.)
• Unscented Hydrating Facial Cream (2 oz)
• Alcohol-Free Toner (2 oz)
• 4 MicroDermabrasion Application Sponge attachments
• Large and Small Pore Refiner attachments
• Cleansing Brush attachment
• Cool mist to close pores
• 2 speeds — HI and LO
• Hard storage case for attachments and drawstring bag for appliance and lotions
Instructions For Use
To Charge:
Follow this procedure before you use this product for the first time.
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider
than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not change the plug in any way.
1. Plug the charger base into a 120-volt outlet. Place the unit into the base and allow it to charge for
at least 16 hours before using it for the first time.
2. The indicator light on the base will glow red when the unit is correctly placed in the charger base.
This is an indication that the unit is charging. The red LED indicator will turn off when the unit is
removed from the base.
3. The optimum voltage for charging is 120V.
4. To maintain the unit's full performance, it should always be placed back on the charging base
after use.
NOTE: Charge for at least 16 hours before using the unit for the first time
NOTE: For best results, use this unit after a shower or after you have steamed your face so that
pores are open and ready for deep cleansing.
4
To Use the Spinning Attachments:
1. Select the desired attachment to begin your facial.
• Cleansing Brush – Use with your favorite soap or facial cleanser provided to gently
cleanse face and neck
• Microdermabrasion Sponge – Use with MicroDermabrasion Cream to exfoliate
2. Snap on attachment (Fig. 2).
3. Select your desired speed – Press the on / off button once for LO and twice for HI.
Corresponding LEDs will light to indicate LO or HI.
4. When finished, turn the unit off, remove and rinse the attachment.
5. Place facial unit back into the charging base.
Figure 1
Facial
Cream
MicroDermabrasion
Cream
Cleansing brush
Facial
Toner
Large Pore Refiner
Small Pore Refiner
(4) MicroDermabrasion sponge
5
Mist
Sprayer
Mist
Button
On/Off
Facial
Unit
Charging
Base