EarthQuaker Devices Astral Destiny Operación Manual página 4

Presets can be stored and overwritten in both Live and Preset Modes. To edit an
existing preset, you must first be in Preset Mode before making the desired changes.
There is no undo for preset saving, so make sure you are not overwriting your favorite
sound, especially when you are saving presets from Live Mode!
Access a Preset
1. Turn the Preset rotary switch to the desired selection.
2. Hold down the Activate footswitch for 2 seconds.
3. The Activate LED will turn Yellow indicating you are now in Preset Mode.
4. Once in Preset Mode, you can turn the Preset rotary switch to access any of the
8 stored presets.
Save a Preset
1. In either Live or Preset Mode, turn the Preset rotary switch to the desired location
you wish to save your preset.
2. Dial in the settings you want to save. EXP assignment and Stretch length can
also be saved!
3. Hold down both footswitches until both LED's flash 4 times then release.
4. Your preset is now saved!
Edit/Overwrite a Preset
1. Once in Preset Mode, make the desired changes to any of the controls in the selected
preset. Any controls that have not been changed will remain as previously saved.
2. The Activate LED will flash Yellow indicating a change has been made to the stored preset.
3. Hold both footswitches down until both LED's flash 4 times and then release.
4. The Activate LED will return to static Yellow and the previous preset has been overwritten.
Return to Live Mode
1. While in Preset Mode, hold down the Activate Footswitch for 2 seconds.
2. The Activate LED will flash then return to the color selected by the bypass state
indicating you are now in Live Mode.
3. Once in Live Mode, the Astral Destiny will return to where the panel controls are set.
<<< Factory Reset >>>
If you would like to erase all of your saved settings and presets and return the Astral
Destiny back to its natural factory shipped state, you can do a Factory Reset. Please
keep in mind that once the pedal has been reset, you will erase all of your saved
information and it can no longer be recalled.
If you would like to return the Astral Destiny to the factory settings, follow these steps:
1. Unplug the power cable.
2. Hold down both footswitches.
3. Insert the power cable.
4. Both LED's will flash 3 times then release both footswitches.
5. Your Astral Destiny has now returned to the factory settings.
6
<<< Power Requirements >>>
3.
Current Draw: 85 mA
This device takes a standard 9 volt DC power supply with a 2.1mm negative center
barrel. We always recommend pedal-specific, transformer-isolated wall-wart power
supplies or multiple isolated-output supplies. Pedals will make extra noise if there is
ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal
specific power supplies do not filter dirty power as well and let through unwanted
noise. DO NOT RUN AT HIGHER VOLTAGES!
<<< Tech Specs >>>
Input Impedance: 500 kΩ
Output Impedance: 100 Ω
<<< Warranty >>>
This device has a limited lifetime warranty. If it breaks, we will fix it. Should you
encounter any issues, please visit www.earthquakerdevices.com/warranty.
7