Modos De Operación - MTX IoT-XS Guía De Usuario

5.2 Modos de operación
La siguiente tabla resume brevemente los modos de funcionamiento del MTX-IoT-XS a los que se hace
referencia en los siguientes capítulos.
LÍMITES FUNCIÓN
Normal GSM/GPRS/
operation UMTS/HSPA
GSM/GPRS/LTE
GSM TALK/GSM
DATA
GPRS DATA
EGPRS DATA
LTE DATA
Power Down Normal shutdown after sending the power down command. Only a voltage
regulator is active for powering the RTC. Software is not active. Interfaces are not
accessible. Operating voltage remains applied.
Airplane Airplane mode shuts down the radio part of the module, causes the module to
mode log off from the network and disables all AT commands whose execution requires
a radio connection. Airplane mode can be controlled by AT command.
MTX-IoT-XS | 2021/04
MTX © by MATRIX ELECTRONICA S.L.U.
SUPPORT: iotsupport@mtxm2m.com | SALES: info@mtxm2m.com |
Power saving automatically activated when no calls
are in progress, the USB connection is suspended
by the host or not present, and there is no active
communication via ASC0
Power saving is disabled if a USB connection is not
suspended, but no call is in progress
Connection between 2 subscribers in progress. Power
consumption depends on the GSM network coverage
and several connection settings (e.g. DTX off/on, FR/
EFR/HR, hopping sequences and antenna connection).
The following applies when power is to be measured in
TALK_GSM mode: DTX off, FR and no frequency hopping
GPRS data transfer in progress. Power consumption
depends on network settings (e.g. power control level),
uplink/downlink data rates and GPRS configuration (e.g.
used multislot settings)
EGPRS data transfer in progress. Power consumption
depends on network settings (e.g. power control level),
uplink/downlink data rates and EGPRS configuration
(e.g. used multislot settings)
LTE data transfer in progress. Power consumption
depends on network settings (e.g. TPC Pattern) and data
transfer rate.
mtxm2m.com
18