Installation - HAMPTON BAY HB-7951-02 Guía De Uso Y Cuidado

Installation

1
Removing the control cover
□
Twist the bottom of the doorbell (A)
counterclockwise to remove the control
cover (1).
2
Removing the battery cover
□
Push the battery cover tab toward the battery
cover (2) and pull to remove.
3
Installing the batteries
□
Install six alkaline "AA" batteries (not included)
into the doorbell (A). Ensure batteries are
oriented correctly.
□
Replace the battery cover (2) onto the
doorbell (A).
NOTE: In typical use, alkaline batteries will last up to
one year.
4
Syncing the doorbell and push
button
□
Press and hold the "SYNC" button on the bottom
of the doorbell (A) until the doorbell (A) sounds
a "Beep-Beep".
□
Press the push button (not included) within
30 seconds. The doorbell (A) will sound a
"Beep-Beep" tone to indicate the push button
is synced.
□
Press the push button to ensure operation.
TUNE – HOLD
1 SECOND.
SYNC – HOLD
3 SECONDS.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
1 SECOND.
SYNC – HOLD
3 SECONDS.
RESET – HOLD
10 SECONDS.
"AA" 1.5V
"AA" 1.5V
"AA" 1.5V
TUNE – HOLD
1 SECOND.
SYNC – HOLD
3 SECONDS.
RESET – HOLD
10 SECONDS.
4
A
1
A
2
A
TUNE – HOLD
1 SECOND.
SYNC – HOLD
3 SECONDS.
RESET – HOLD
10 SECONDS.
30
A