NORPOLE NPCIM90B Manual Del Usuario página 9

INSTALLING THE ICE MAKER
1. Verify that the unit is in good condition and all parts and accessories are present. Check the model and serial number on the label and write
them down for reference.
2. Open the bin door and remove the packaging tape from the ice thickness sensor and the flap. They are used to avoid possible damage during
transportation only.
3. Clean the ice ice bin and the food area inside with a sponge soaked in warm water and soda. Then wash and dry it with potable water.
4. Place the ice machine in the operation area; ensure that the machine is placed on a leveled floor. So as to ensure the water flows evenly on the
evaporator.
5. The compressor chamber is located below the front of ice bin. The compressor and condenser are installed in it. It requires good ventilation.
Therefore, the front and rear of the ice maker must have ventilation space of more than 8-12 in.(20-30cm).
6. The bottom of the ice machine is equipped with adjustable legs for level adjustment and floor cleaning. Use these to make sure the ice maker is
level.
7. Connect the machine's inlet water filter and water pipe referring to the schematic diagram of installation; if the installation site is already
equipped with a water filtration system, the filter may not be needed.
NOTE: Make sure to install the filter so the water is flowing in the direction noted on the filter head cover or filter body.
NOTE: This machine is equipped with an inlet water filter. The filter will remove impurities from the water used as the the machine is running.
Generally, it needs to be replaced every month to every 3 months.
8. Connect the machine to the water supply using the 3/4" inlet pipe supplied with the machine. It is recommended to install a water valve (not
supplied with this machine) on the water supply line.
9. No part of the drain pipe should be higher than the drain port on the unit, and must not have any inclines.
10. Confirm that all power requirements stated on the ratings label are met, and that the unit is connected to a properly installed, working and
grounded circuit breaker.
11. Make sure the power switch is 'Off' before connecting the ice maker to the power supply.
9