Replacing The Fuse; Replacing The Chain - Razor DIRT QUAD Manual Del Propietário

REPAIR AND MAINTENANCE
q Replacing the Fuse
1
Make sure the power switch
is turned OFF.
Amperage
number
4
Remove the fuse and replace
with a new one of equal
amperage.
Note: Amperage rating is
located on top of fuse.
q Replacing the Chain
Tools required: 6mm key wrench, 10mm wrench and Phillips screwdriver.
1
Remove the bolt and wash-
ers on the outside of the rear
wheel.
4
Remove the 2 screws from
the bottom half of the chain
guard and remove.
2
Under the front fender and
through the frame, locate the
fuse box attached to the top of
the battery.
5
Close the fuse cover.
2
Remove the bolt on the
inside of the rear wheel.
Remove nut and pull bolt out
of axle.
5
Spread the chain tensioner
apart to loosen chain.
3
Open the fuse cover to
expose the fuse.
3
Remove the 3 screws from
the top half of the chain guard
and remove.
6
Remove chain from both
sprockets and replace with new
chain.
5
WARNING:
To prevent shock, please follow
the instructions accordingly
and do not skip or combine any
steps.
WARNING:
Do not touch motor after use.
Motor is (or can be) very hot.