Stocker Solarjet Inox 0500 Manual Del Usuario página 8

Introduction
Thank you for purchasing a quality unit. Used carefully and in accordance with the instructions set out below your
GARDEN LAMP should give you many years of trouble free use. Please read the instructions carefully to obtain
the best results from your purchase.
Stylishly designed, your unit features:
Robust & attractive Black plastic construction
•
Direction for solar panel can be adjusted freely
•
Angle of the spotlights can be adjusted freely
•
Solar powered by high quality crystalline solar panel
•
3pcs Super bright LED
•
No Mains Power or wiring required
•
Up to 8 hours run time
•
Automatic sensor turns the light on at dusk
•
2 x Solar Rechargeable AA Ni-MH batteries included
•
Auto/Off switch
•
Location of the SOLAR LAMP
1) For the best result, please locate your solar lamp in a position
where it can get direct sunlight on the solar panel, and generally
free from cover and shade. (As shown in figure 1).
2) Make sure that the photo sensor (located on the top of the light)
is not going to be affected by any other light source. Otherwise the light will not illuminate at dusk.
3) The SOLAR LAMP must be left to charge for 2 sunny days before best results are achieved.
Assembly Instructions
1) Carefully remove the UNIT and all the fittings out of the box.
2) Assemble the mounting poles (2), and stakes (3); Push the stake directly into the ground
(DO NOT hammer the light or the stakes) (as shown in figure 2).
3) Slot the controller head (1) on the upper part of the mounting poles carefully.
4) Adjust the solar panel to the direction which can get direct sunlight
5) Release the knob by twisting it anti-clockwise and adjust the angle of the spotlights to
any direction you prefer, fix the knob by twisting it clockwise
6) Adjust the switch under the lid of the lamp unit to "AUTO" position.
Instruction Manual –
-