Manual Defrost - miniland baby warmy digy Manual Del Usuario

NOTE 2: When heating jars of baby food, stir the baby food with a spoon for 15-20
seconds after completion so that the temperature is evenly distributed throughout the
content.

5.2. MANUAL DEFROST

1. Place the device on a suitably flat surface, making sure that it is out of the reach of
children.
2. Insert the plug into the electrical socket. A beeping will be heard and the LED power
status indicator (11) will illuminate with a green colour.
3. Fill the bottle warmer with drinking water up to the level of the milk/baby food in
the bottle/container. In case of large amounts of milk/baby food, the maximum level
of water is approximately 1 cm below the top of the bottle warmer.4. Next, using the
selecting arrows, adjust the heating time so that the water introduced into the appliance
boils. Once the water is hot, turn off the appliance by pressing and holding the power
button (10) for 4 seconds.
5. Insert the receptacle to be heated into the body of the device contained by the basket (5).
At this setting, your frozen milk can be defrosted till liquid state.
6. If after cooling of the water in the appliance, the bottle is still frozen, please repeat
the previously numbered steps.
When your milk is defrosted, choose one of the warming settings. Consider the start
temperature of your milk/baby food around room temperature for the warming timings
as rough guideline.
5.3. LOCATING FAILURES
SYMPTOMS
The screen is turned off
The screen flashes and an
alarm sounds
The device has reduced
effectiveness when heating
The device works but it does
not heat up
Other malfunctions
6. MAINTENANCE
Follow the instructions below for any maintenance tasks:
• The device itself (main body):
· Always power the device down and unplug it before proceeding with any cleaning
tasks.
· Only use a damp cloth to clean it.
• The device itself (heating chamber):
· Depending on the quality of the water used, lime deposits may build up over time at
the base of the heating chamber. These lime deposits must be removed regularly
by pouring a mixture of 100 ml of hot water and 100 ml of white vinegar into the
POSSIBLE CAUSES AND CORRECTIVE
MEASURES
Check that the device is plugged in and push
the power button.
There is not enough water in the heating
chamber. Replenish it and restart the process.
Check if there are any lime deposits in the
heating chamber. Clean the chamber by
following the instructions in point 6 as many
times as may be necessary nor normal
operation to be restored.
Get in touch with the Miniland technical service.
15
ENGLISH