A - Things That Must Be Done Before Using Your Product And - Ugur UFR 370 SD Guia Del Usuario

A- THINGS THAT MUST BE DONE BEFORE USING YOUR
PRODUCT AND SECURITY WARNINGS
WARNING!
• Do not place your product to a place exposed to direct sunlight or infl uence area of the heat sources
such as stove, radiator core, oven, cooker, radiant and infrared. Otherwise, this may cause performance
decrease, damage of your product or make it become dysfunctional. (Picture 1)
• Your product is set for operating at mains power of 220-240 Volt 50 Hz. Using your product with a diff e-
rent voltage may cause it become dysfunctional and fire. (Picture 2)
• Our company is not responsible for the failures and material damages that may occur in case of using
without grounding.
• Electrical installation must conform to national regulations.
• There must absolutely be a residual current relay and a fuse in your electrical installation for preventing
the risks of electrical shock and fire.
• Place the device in a damp-free place with unobstructed air circulation.
• You must clean inside your product before the first use.
• After placing your device to its place, wait for one (1) hour without moving it before starting using.
• If your device is installed under very cold weather conditions, then the waiting period must be at least
two (2) hours before starting to operate it.
• In case of prolonged blackouts, do not open the door of your products for preventing heat loss.
• If you do not use your device or leave it empty for a short time, do not unplug it for saving energy.
Otherwise, more energy will be consumed for re-cooling your product.
• In products, the doors of which are left opened or opened and closed continuously, frost deposit will
increase and no cooling operation will be carried out. Thus open the doors of your product only when
needed. Make sure that the doors are closed if not required.
• Unplug your product in case of sudden blackouts. For starting again, plug in your product 20 minutes
EN after the electricity is supplied. High voltage occurring at the moment of electricity supply may cause
damage of your product and fire.
• Do not allow wild animals and pets to enter into your product or walk around it. It may damage your
product or cause death and injury of the animals. Furthermore, wild animals and pets may cause fire by
giving harm to the electrical installation.
• Your device does not have any sterilizing eff ect on the microorganisms. Therefore it is necessary that
the foodstuff you place into your product must conform to the hygiene standards and packaged. Ot-
herwise, microorganisms reproducing in foodstuff may pose a threat for your health.
PICTURE 1
220- 240 Volta
50 Hz. %10
PICTURE 2
36