Shure UA845 Guia Del Usuario página 12

MULTIPLE UA845 SETUP
1. Connect the CASCADE ports (connector 5) for RF OUTPUT Channels A
and B of one UA845 to the ANTENNA INPUT, channels A and B, of a
UR4 receiver, a UC4 receiver, or a second UA845.
2. If desired, connect additional units in the same manner.
3. To daisy-chain UR4 Receivers together with Power OUTPUT cables, con-
nect the Power OUTPUT connector of the UA845 to the Power INPUT
connector of one receiver. Connect the remaining receivers similarly.
Connect the POWER INPUT of the unit to an AC power supply.
AC PWR OUTPUT
TO POWER SUPPLY
TO POWER SUPPLY
TO UA845 ANT B IN
ENGLISH
12 VDC POWER CONNECTOR
ANT B IN
AC PWR INPUT
TO
RECEIVERS
AC PWR OUTPUT
AC PWR INPUT
12 VDC PWR INPUT
TO RECEIVERS
MULTIPLE UA845 SETUP
WARNING: When adding additional UA845's to a system, each
UA845 should be connected to a separate power supply.
than five (5) receivers can be powered from a single UA845.
sy-chaining multiple UA845's through the Power OUTPUT ports
will overload a single power supply, possibly causing damage to
the equipment.
4. To power Shure UC4 receivers, connect the power input ports of the UC4
receivers to the 12 Vdc OUT of the UA845. Up to four UC4 Receivers
can be powered.
UA845
CASCADE A
CASCADE B
ANT B OUTS
ANT B IN
UR4 RECEIVER
UR4 RECEIVER
ANT A IN ANT B IN
UA845
UR4 RECEIVER
FIGURE 9
12
12 VDC POWER CONNECTOR
ANT A IN
ANT A OUTS
TO
RECEIVERS
ANT A IN
TO
RECEIVERS
No more
Dai-
TO UA845
ANT A IN