Lutron Radio Powr Savr LRF2-DCRB Manual Del Usuario página 3

Radio Powr SavrT Occupancy/Vacancy Sensor (LRFX-OWLB-P, LRFX-OKLB-P, LRFX-OHLB-P,
LRF2-VWLB-P, LRF2-VKLB-P, LRF2-VHLB-P, LRFX-OCR2B-P, LRF2-VCR2B-P, LRFX-OCRB-P)
and GRAFIK EyeR QS Wireless Control Units (wireless enabled units only)
To associate the sensor with the GRAFIK EyeR QS Wireless
Control Unit using the green laser method, do not follow the
instructions that accompany the GRAFIK EyeR QS Wireless
Control Unit. Instead:
1. M ake sure the wireless mode of the GRAFIK EyeR
QS control unit is Enabled (see the GRAFIK EyeR QS
installation guide).
Note: To properly save the wireless mode, exit and then
re-enter programming mode before associating wireless
sensors.
2. E nter programming mode on the GRAFIK EyeR QS unit
(see installation guide).
3. U se the Master buttons to highlight "Sensor setup" and
press the OK button to accept.
4. Use the Master buttons to highlight "Add wireless
sensors" and press the OK button to accept.
5. T urn on the laser and pass the beam over the hole in the
sensor. The sensor will flash rapidly, then blink once per
second.
6. O nce the sensor is flashing once per second, pass the
beam of the laser over the hole in the sensor again within
10 seconds. The sensor will flash rapidly, and the room's
lights will flash 3 times. The info screen on the GRAFIK
EyeR QS will display the sensor's serial number. This
indicates that the sensor-base unit association has been
completed successfully.
Note: If the laser is not passed over the sensor hole
again within the 10-second window, the unit reverts to
normal operation.
7. Press the OK button on the GRAFIK EyeR QS control
unit. A screen will confirm that the sensor has been
associated.
8. Exit programming mode on the GRAFIK EyeR QS unit (see
installation guide).
9. T he sensor automatically goes into Test Mode at this
point. When activated by the green laser, Test Mode lasts
for 5 minutes.
Note: in this Test Mode the receiving device will respond
to the occupancy state changes and the occupancy
timeout is 20 seconds.
Application Note #407
1 2 3 4 5 6
3 Technical Support — 800.523.9466 (USA)
Info screen
Master buttons
OK
OK button
+44.(0)20.7680.4481 (Europe)