Important Warnings; Eu Declaration Of Conformity; Technical Data - V2 HURRICANE-RS Manual De Usario

m

IMPORTANT WARNINGS

For technical clarifications or installation problems, contact V2
Customer Service on the Italian Free Phone Number 800-134908
open Monday to Friday from 8:30 to 12:30 and 14:00 to 18:00.
V2 reserves the right to make any changes to the product without
prior warning; furthermore, it cannot be held liable for damage to
people or property due to improper use or wrong installation.
m
Read the following manual carefully before
proceeding with installation and programming of the
control unit.
• This instructions manual is only intended for qualified
technical staff in the automations installation field.
• None of the information contained in this manual can interest
or be useful for the end user.
• Any maintenance or programming operation must only be
carried out by qualified staff.
• The sensor should not be considered a safety device that
eliminates awning faults due to the effect of strong wind.
• The sensor should be considered a useful automation to
safeguard the awning and comfortable for use.
• The manufacturer cannot be held in any way liable for
material damage which could occur due to atmospheric
events not detected by the device sensors.
• Do not make changes to any part of the device. Operations
not permitted can only cause malfunctions. The manufacturer
cannot be held in any way liable for damage deriving from
arbitrary changes to the product.
• Handle the product carefully, avoiding actions that could
damage it such as, for example, crushing, knocks, falls, etc.
• Do not place the device near heat sources or expose it
to open flames. These actions can damage it and cause
malfunctions.
• The product was not intended for use by people (including
children) whose physical, sensory or mental capacities are
reduced, or with lack of experience or know-how.
• Ensure children do not play with the product.

EU DECLARATION OF CONFORMITY

V2 SPA declares the products: HURRICANE-RS
comply with the following directives:
2014/35/UE, 2014/30/UE, 2014/53/UE, 2011/65/CE
Racconigi, 01/06/2015
V2 S.p.A. legal representative
Giuseppe Pezzetto

TECHNICAL DATA

Maximum applicable voltage
Absorbed power
Transmission frequency
Protection
Temperature for use
230 V~ 50Hz
3,5 W
434,15 MHz
IP44
-20 ÷ +60 °C
DESCRIPTION OF THE PRODUCT
The HURRICANE-RS sensor detects the sun, wind, and
temperature parameters and if the SUN threshold is exceeded,
an OPEN command is sent to the sunshade, whereas if the WIND
threshold is exceeded, a CLOSE command is sent.
Using 2 buttons and 8 LEDs, the thresholds for the sensors can be
set and the device can be memorized on the controlled remote
controller.
CAUTION: If the system is left unattended for long periods,
we recommended that the sunshade be closed and that the
sun sensor's automatic function be deactivated.
1. DEVICE MEMORIZATION ON REMOTE
CONTROLLERS
1.
Move to a position close to the remote controller that will be
controlled
2.
Power the device with a temporary cable
3.
If the sunshade is controlled with transmitters in the PROTEO
series, use a remote control that is already memorized in the
controller and proceed as follows:
a. Multichannel transmitter only: Press SELC on the
transmitter a few times, until the LEDs display the channel
memorized
b. Return the awning to its mid-height
c. Move Switch 1 on the transmitter to the ON position
d. Press and hold down PROG on the transmitter for about 5
seconds, until the motor starts to move
e. Release PROG
f. Press P1 on HURRICANE-RS for at least 2 seconds (Fig.2)
g. To check that it has been memorized correctly, press P1:
the sunshade should CLOSE. If not, repeat the procedure
4. If the sunshade is controlled with transmitters in the ARTEMIS
series, use a remote control that is already memorized in the
controller and proceed as follows:
CAUTION: If the remote control used has multiple
channels, first select the channel memorized in the
controller using C.
a. Press and hold down the UP and DOWN buttons on the
remote control until the motor starts to move in one
direction.
b. Release the buttons.
c. Within 8 seconds, press P1 on HURRICANE-RS for at least
2 seconds
d. To check that it has been memorized correctly, press P1:
the sunshade should CLOSE. If not, repeat the procedure.
- 6 -