Electrical Safety - Silverline 345678 Manual Del Usuario

Electrical safety

Earthed
GREEN/YELLOW
OR GREEN
BROWN
BLUE
(Live)
(Neutral)
• The wires in this product are coloured:
Blue
Brown
Green & Yellow
• This appliance must be protected by a suitable fuse.
• To prevent fire or shock hazard, do not expose this product
to rain/water or moisture.
• There are no user serviceable parts inside except those
referred to in this manual.
• Always refer servicing to qualified service personnel.
Never remove any part of the casing unless qualified to do
so; this unit contains dangerous voltages.
• Use of a residual current device will reduce the risk of
electric shock.
Dangerous environment
• Do not use power tools in damp or wet conditions, or
expose them to rain. Provide adequate surrounding work
space and keep area well lit. Do not use power tools
where there is a risk of explosion or fire from combustible
material, flammable liquids, flammable gases, or dust of
an explosive nature. When using power tools avoid contact
with any earthed items such as pipes, radiators, cookers,
refrigerators, metal baths and taps.
Maintain your power tool
• Ensure all ventilation holes are kept clear at all times.
Overheating and fire may otherwise result.
Always disconnect
• Before changing fittings or accessories, always ensure
that your tool is disconnected from the power source.
Switch off before connecting
• Ensure that the power tool is switched off before
connecting to the power source. If the power tool stops
unexpectedly, turn the power switch to off.
345678_instructions.indd 6
Double Insulated
FUSE FUSE
BROWN
BLUE
(Live)
(Neutral)
Neutral
Live
Earth
Do not abuse the power cord
• Be sure your cable / extension cable is in good condition.
Always have a damaged cable / extension cable replaced
at an authorised service centre before using it. Never yank
or pull the cable to disconnect it from the power socket.
Never carry your tool by its cable. Keep the cable away
from damp, heat, oil, solvents, and sharp edges.
Don't leave the tool running unattended
• Always wait until your tool has completely stopped
functioning, and has been unplugged, before leaving it.
Water pump safety
• Only install this pump where you know it is entirely safe
to do so. If you are unsure of the correct and safe way to
install this pump, consult a qualified plumber.
• This pump must always be installed horizontally, with
properly connected pipe fittings. Ensure that the pump
is properly supported and that pipe connections are not
strained.
• Ensure that the pump is connected to a reliable water
supply. If the pump is allowed to run dry, or is exposed to
freezing temperatures, permanent damage will result.
• The pump must be installed in a dry place with good
ventilation. Do not allow the pump, or electrics to become
wet.
4
16/11/2010 12:26