Human Touch Perfect Chair PC-350 Manual De Uso Y Cuidado página 4

get ready
UNPACK THE BOXES
Chair frame Headrest frame
Arm core
Arm cap (2)
Screw (4)
Screw (6)
ATTACH THE BACKREST FRAME
1. Raise the chair to an upright position.
For your convenience, and to better position the chair for the remaining
assembly, plug in the chair, then use the electric recline lever to adjust the chair
to an upright position.
CAUTION: Plug the chair into an appropriate power source. Be sure that the
power cord lies beneath the mechanics located underneath the chair.
2. Remove the backrest frame screws.
Using the Phillips-head screwdriver (provided), remove the two
screws from the headrest frame. Retain them for use in step 4.
humantouch.com
Body pad Head pad Head pillow
3/16-inch
Phillips-head
Allen key
screwdriver
4
Your Human Touch Perfect Chair
®
attach the backrest frame, pads, arm caps, and head pillow, and you're done!
3. Insert the headrest frame into the chair frame.
With the backrest frame positioned so that the headrest can
tilt forward, slide the two ends of the backrest frame into the
open tube ends of the chair frame.
4. Replace the backrest frame screws.
Using a Phillips-head screwdriver, replace the two headrest frame
screws, securing the headrest frame to the backrest frame.
5. Install the canvas backrest support.
Pull the chair canvas firmly upward as far as it will go, wrap the
top flap around the backrest frame, align the two hook-and-loop
fastener strips, then press them firmly together. It is important
that the canvas be stretched tight to provide proper back
support.
ATTACH THE BODY PAD
1. Slide the body pad onto the chair frame.
Slide the body pad onto the lower part of the chair frame,
making sure that the frame slides into the fabric pocket located
on the bottom side of the pad.
2. Secure the body pad.
Smooth the body pad into place, from the footrest toward the
seat. Pull up on the backrest pad until the hook-and-loop
fastener strip on the back of the pad aligns with the hook-
and-loop fastener strip on the chair canvas, then press the
two strips firmly together.
requires some simple assembly. Just
®
Canvas
Hook-and-loop-fastener
strips aligned
Hook-and-loop-fastener strips aligned
5 5