Brandson Equipment 303055 Manual Del Usuario página 23

Unscrew the tilt angle - range screw (10) and the tilt angle bolt (3).
Note: It is important that the rotor unit and the centre member are in the correct
position when these are fixed.
The top of the centre bar has an oval indentation and a circular hole. The hole-
side is intended for the tilt angle - range screw (10) and the side with the indenta-
tion is intended for the tilt angle screw (3).
Note: Please follow the assembly sequence shown below carefully!
Slide the tilt angle bolt through the fan as shown in the figure below.
23
English