Care And Maintenance; Wheel Replacement; Cleaning And Disinfection - Pride Mobility Products iRIDE S25 Manual De Usuario

V I I I . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confi dent in your ability to
perform the maintenance listed below, you may schedule inspection and maintenance at your authorized Dealer.
The following areas require periodic inspection and/or care and maintenance.
TIRES
Regularly inspect your scooter's tires for signs of damage or wear.

WHEEL REPLACEMENT

Your scooter is equipped with solid tire inserts. If you have a damaged or worn tire, the entire wheel must be replaced.
Contact your authorized Dealer for information regarding replacement wheels for your scooter.
WARNING! Wheels on your scooter should only be serviced/replaced by a qualifi ed technician.
WARNING! Be sure that the scooter is "OFF" and the battery cord is not connected before
performing this procedure.
EXTERIOR SURFACES
Bumpers, tires, and trim can benefi t from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter's vinyl seat or tire tread. They
will become dangerously slippery.

CLEANING AND DISINFECTION

 Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter. Avoid
using products that may scratch the surface of your scooter.
 If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on
your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning
agent before applying it to your product. Failure to comply may result in skin irritation or
premature deterioration of upholstery and/or scooter fi nishes.
BATTERY PACK CONNECTIONS
Make certain that the battery pack terminal connectors are tight and not corroded.
WIRING LEADS
 Regularly check all wiring connections.
 Regularly check all wiring insulation, including the charger power cord, for wear or damage.
 Have your authorized Dealer repair or replace any damaged connector, connection, or insulation that you fi nd
before using your scooter again.
PROHIBITED! Even though the scooter has passed the necessary testing requirements for
ingress of liquids, you should keep electrical connections away from sources of dampness,
including direct exposure to water or bodily fl uids and incontinence. Check electrical components
frequently for signs of corrosion and replace as necessary.
WARNING! Do not pull on electrical cords directly to detach them from the scooter. Always
grasp the connector itself when disconnecting the cords to prevent wire damage.
iRIDE
35