Jung FMST50UP Instrucciones De Servicio página 8

Regulador fluorescencia 1-10 V eNet 1 fase mini
Dim up ramp
Dim down ramp
Run-on time
Manual switch-off of the run-
on time
Operating hours
Extended channel settings
Parameters
82581023
J0082581023
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
On, Off
Basic setting: Off
0...65535
Basic setting: Current value
Setting options, Basic set-
ting
8/13
Time between switch-on and
reaching switch-on brightness.
The light is switched on at mi-
nimum brightness and then
dimmed to the switch-on brig-
htness.
Only applies to switch-on with
transmitters (short operation).
If scenes are recalled or swit-
ching uses logic modules, the
switch-on brightness is ap-
proached using so-called soft
dimming (not configurable).
Time until reaching minimum
brightness. The light is dim-
med to minimum brightness
and then switched off.
Only applies to switch-off with
transmitters (short operation).
If scenes are recalled or swit-
ching uses logic modules, the
system switches off directly.
As soon as a run-on time has
been entered, the actuator will
no longer remain on perma-
nently, but only for the length
of the run-on time. The run-on
time is restarted if actuation is
repeated. This parameter is di-
rectly connected to the "Ma-
nual switch-off of run-on time"
parameter.
Note: The set time apply to
operation using radio transmit-
ters. The device is switched
immediately when the Prog
button is pressed.
Allows manual switch-off of a
running run-on time. If the pa-
rameter is switched off, then a
switch-off command will also
switch the actuator on. Only
visible if a run-on time was
set.
The time is counted during
which the load is physically
switched on.
This parameter can be reset to
"0", for example after exchan-
ging the load.
The Reset button is used to
reset the meter to "0". The de-
vice must be programmed to
apply the change.
Explanations
29.03.2017