Starting Operation; Components And Controls - Pulsar ACCOLADE 2 LRF Guia De Inicio Rapido

ENGLISH

Starting Operation

Powering on and image setting
Open the lens cover (10).
•
Press the ON/OFF button (1) briefly to power the device on.
•
• Set the pupillary distance by squeezing the eyepieces together or pulling
farther apart while holding the adjustment rings (6).
• Get a sharp image of the symbols on the display by rotating the optical
adjustment ring of the eyepieces (7).
Rotate the lens focus ring (8) to focus on target.
•
Select the calibration mode: manual (M), semi-automatic (SA) or automatic
•
(A) in the main menu (enter the menu by long pressing the MENU button (3)).
Press the ON/OFF button (1) briefly to calibrate the image (close the lens
•
cover for manual calibration if the calibration mode is (SA) or (M)).
Select the operating mode (Forest / Rocks/ Identification / User Mode). Hold
•
down the DOWN button (5) to call up a Menu item. Press the DOWN button
(5) briefly to switch modes. The USER MODE allows you to set and save user
brightness and contrast parameters.
• Adjust the brightness, display contrast, smooth digital zoom in the quick
menu (activate by briefly pressing the MENU button (3).
Turn off the riflescope by long pressing the ON/OFF button (1) after use.
•

Components and Controls

Navigation
button UP
Button ON/OFF
Navigation
button DOWN
Interpupillary
distance
adjustment
rings
1
ENGLISH
2
1
5
6
Lens focusing ring
Dioptre
7
adjustment rings
8
7
3 Button MENU
4 Recording button REC
9 Battery Pack
Interpupillary
6
distance
adjustment
rings
10 Lens cover