Making Analog Connections; Adjusting The Volume Balance - Yamaha MusicCast SUB 100 Manual De Instrucciones

Making analog connections

Use the ANALOG jack on the rear panel of this unit if you want to connect this unit directly to other devices (such as a
sound bar) without connecting to a network.
(Connection example)
Sound bar etc. with
ANALOG output jacks
1.
Connect this unit's rear panel ANALOG
jack to the subwoofer output jack or line
output jack (e.g., PRE OUT) of the
connected device.
2.
Set this unit's rear panel INPUT switch to
ANALOG.
3.
Insert the power cord plug into an AC
outlet.
4. Press the rear panel A (STANDBY/ON)
button to turn on the power of this unit.

Adjusting the volume balance

In order to ensure effective low-frequency playback, you can adjust the volume so that the sound of this unit blends
naturally with the speaker that you're using.
■
If using a network connection
If this unit is connected to a network, the volume of this
unit is automatically adjusted to match the Pairing Master,
but you can make fine adjustments to your taste by using
the top panel GAIN knob.
Default value: Depends on the setting of the Pairing
Master
(rear panel)
3.5 mm
monaural
mini plug
NOTICE
● Do not connect the power cord to the AC outlet until all
connections are completed.
● Depending on the device (sound bar, etc.) that you're
connecting, the connection method and the names of the
jacks might differ from this instructions in this
document, so you should also refer to the owner's
manual of the respective device.
● When this unit is shipped from the factory, its volume is
set to the minimum setting. When you have finished
making connections, make adjustments so that this unit
produces an appropriate volume.
■
If using an analog connection
Use the top panel GAIN knob to adjust the volume of this
unit.
High-cut filter frequency: fixed at 160 Hz
Default value: MUTE
GAIN knob
(top panel)
CONNECTIONS
NS-NSW100
English
17
En