Hermann Bock SR2 Instrucciones De Uso Y Montaje página 23

EN
Slide the spacer onto the shoulder bolt.
Push the side rail with the attachment bolt
into the larger hole as far as it will go.
Between the U-profile, adjust the sleeve
as a spacer when inserting.
From the inner side, tighten the screw as
shown.
Move the side rail SR2 to the upper posi-
tion.
Attention: The dimension between
the vertical outer edge of the side rail
and the nearest possible component
must be 30 mm in the horizontal di-
rection.
Tighten the upper screw M8x40mm.
Functional check. Lower the side rails and
put them back in place.
9