Disassembly Of The Side Rail Sr2; Operation Of The Side Rail Sr2 - Hermann Bock SR2 Instrucciones De Uso Y Montaje

Tighten the screw from the inside as shown in
the picture.
Functional check. Lower the side rails and put
them back in place.
2.6

Disassembly of the side rail SR2

Disassembly of the side rail SR2 is done in reverse order to assembly.
2.7

Operation of the side rail SR2

Each side rail element can be adjusted independently. The release button for the adjust-
ment is located in the middle of the side rail SR2, this release button must be pulled down-
wards and with the other hand pulled on the corresponding longitudinal bar of the side
rail.
To lower a side rail SR2, grap the upper bar of the side
rail with one hand and release the release button with
the other hand by pulling it slightly downwards.
The side rails SR2 can then be lowered in one longitudi-
nal movement
11
EN