Mounting The Ball Valve Onto Storage Tank; Connecting The Water Lines; Connecting The Tubes Using Quick-Connect Fittings - PUR PQC3RO Manual Del

Installation Instructions (continued):
Mounting the Ball Valve Onto Storage Tank (See Figure 11 and 12):
1. Connect the Ball Valve to the water Storage Tank thread on the upper side
of the Tank. Make sure the Black Rubber Gasket sits flat. Tighten the valve
but do not overtighten.
2. Connect the 1/4" Yellow Tubing to the Ball Valve. Push the Tubing in all
the way to make sure it is properly seated.
3. Turn the Ball Valve off.

Connecting the Water Lines:

CAUTION: Before cutting the supplied tubing, measure the distance
between the components.
All Tubing is color-coded for ease of installation.
1/4" Black: Connects the waste water from the RO Membrane to the
Air Gap Faucet Intake Line.
1/4" Red: Connects the Inlet Valve of the cold water supply to the
inlet of the system.
1/4" Yellow: Connects the RO Membrane to the Storage Tank.
1/4" Blue: Connects the outlet of the system to the Faucet.
3/8" Black: Connects the Faucet to the Saddle Drain Clamp.
Note: Reference the diagram on page 3, 4 or 5 for color and
connection point on the RO System.
Each plumbing connection point has a Colored Plug to match the color of the
tubing for simple installation reference. Discard plugs after the tubing has been installed.
Quick-connect fittings are used throughout the system. To ensure an optimal seal, tubing should be cut with the end square.
An angled cut or distortion of the tubing will not provide a proper seal and may cause leaks.
Connecting the Tubes Using Quick-Connect Fittings (See Figure 13, 14 and 15):
1. Remove the Blue Horseshoe Clip from the Collet.
2. Pull out and discard the Colored Plug by pushing the Collet inward and holding with your fingers.
3. Insert Tubing into the Collet. Full engagement is 11/16" length of the Tubing into the Fitting for 1/4" Tubing, and 3/4" length
for 3/8" Tubing.
NOTE: Ensure the Tubing is pushed all the way into the backstop.
4. Re-install the Blue Horseshoe Clip into the Collet.
Figure 13
Collet
Horseshoe Clip
Figure 14
O-Ring
Figure 11
Rubber
Gasket
Storage Tank
Figure 12
Closed Open
Ball Valve
Storage Tank
Figure 15
Backstop
Full engagement length
Remove
Protective
Cap
1/4"
Yellow
Tubing
10