Mounting The System Under The Sink; Connecting The Tubes Using Quick-Connect Fittings - PUR PUN2FS Manual Del Propietário

Installation Instructions (continued):
Mounting the System Under the Sink (See Figure 6):
1. Choose an easy to access area under the sink to mount the system.
NOTE: There must be a 2" minimum clearance between the
bottom of Filter Sump (B) and the floor of cabinet to facilitate
easy replacement of filter cartridge.
NOTE: Mount the system to a solid cabinet wall. If a solid wall
is not available, use hollow-wall anchor bolts or toggle bolts
(not included) to secure to the wall.
2. Use the Pre-Assembled Head Assembly (A) as a template, mark the
holes for positioning the system on the wall surface.
3. Insert Mounting Screws (F) into the wall with a Phillips screwdriver.
Leaving approximately 3/8" of each screw exposed. Hang the
system through the eyes of the bracket on the screws. Tighten the
screws to secure the system.
4. Push the ends of the tubing into the inlet & outlet of the Head
Assembly (A) by referring to"Connecting the Tubes Using Quick-
Connect Fittings" below.
CAUTION: Do not kink tubing as this will impede water flow.
Connecting the Tubes Using Quick-Connect Fittings (See Figure 7, 8 and 9):
1. Remove the Blue Horseshoe Clip from the Collet.
2. Pull out and discard the Plug by pushing the Collet inward and holding with your fingers.
3. Insert Tubing into the Collet. Full engagement is 11/16" length of the Tubing into the Fitting for 1/4" Tubing.
NOTE: Ensure the Tubing is pushed all the way into the backstop.
4. Re-install the Blue Horseshoe Clip into the Collet.
Figure 7
Collet
Horseshoe Clip
5
Figure 8
O-Ring
Figure 6
Faucet
Faucet Shank
Water
Inlet
B
1/4" White Tubing
Minimum 2" Clearance
Figure 9
Full engagement length
1/4" White
Tubing
Water
Outlet
A
F
B
Backstop