Tabla de contenido
Publicidad
INSTRUCCIONES IMPORTANTES DE SEGURIDAD
30287
REF.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
INSTRUCTION MANUAL
EN
MODEL 30287
SAFETY INSTRUCTIONS
READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR FUTURE CONSULTATION - WARNING: TO REDUCE THE POSSIBLE
RISKS OF FIRE, ELECTRICAL DISCHARGES OR PERSONAL INJURY, TAKE THE FOLLOWING INTO ACCOUNT
1. HOW TO USE
- Remove all packaging of the lamp.
- Clamp the bracket to the edge of any horizontal surface which you have chosen.
- Insert the bottom stem of the arm into the hole in the bracket.
- Plug in the magnifier lamp.
- Switch on the lamp by pressing the ON/OFF switch.
- Place the lamp head in the desired position.
2. CHANGE OF THE TUBE:
- Switch off the magnifier lamp and take out the plug. Wait till the lamp cools down before changing the tube.
- Rotate the lamp head so that you can see the tube.
- Take off the transparent tube protection cover and place it aside.
- Unplug the 4-pin connector of the old tube from the lamp holder and discard it safely.
- Push-fit the 4-pin connector of the new tube into the lamp holder. Press the new tube into the bulb clips to
secure the tube is held tightly.
- Put on the tube protection cover.
3. IMPORTANT SAFE USE
- Only indoor use.
- Environment temperature: -20ºC/40ºC
- Humidity: <95%
- Never disassemble the magnifier lamp unless you are a qualified electrician.
- Plug must be taken out while repairing the magnifier lamp.
- Never leave the lens unattended in direct sunlight or where light can shine through it. This may cause a fire
hazard!
4. If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
TECHNICAL CHARACTERISTICS
12W - G10Q
220/240V - 50Hz (AC)
Lens diameter: Ø90mm
Magnifying power: 3 diopter, 12 diopter
-4-
Publicidad
Tabla de contenido
