Pre-Operation - Casals JHB70 Manual Del Usuario

existing parts/accessories.
- Any misuse or failure to follow the instructions
for use renders the guarantee and the manufac-
turer's liability null and void.
DESCRIPTION
A Pump switch on/off
B Water Connection tuve (not included)
C Water Inlet*
D High pressure tube
E Water Outlet*
F Spray gun
G Extension Pipe
H Spray nozzle pipe
I Nozzle**
J Detergent conatiner*
K Soap Nozzle*
L Mains power cord
M Tip Cleaner
(*) Change position depending on the model.
(**) Nozzle in JHP18 has two adjustable rings.
One for spray angle and other for pressure level.
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE
MOUNTING THE APPLIANCE
- Attach the High-pressure tube to the water
outlet of the machine ensuring that's is well
connected (Fig.1 Change position depending on
the model).
- Attach the spray gun to the high-pressure tube
(Fig. 2).
- Mount the extension pipe (Fig. 3), the soap
nozzle (Fig. 4) or the spray nozzle pipe into the
spray gun (Fig. 5)
- Connect the machine to water and power
supplies.
- NOTE: If you notice that the appliance have
some loses in water connections, you could use
teflón tape in order to improve this connections.
- WARNING: Ensure that high-pressure tube is
completely uncoiled before any use.
- WARNING: The water entering to the appliance
should not exceed the 50ºC.

PRE-OPERATION

- Useful information for during the use.
- WARNING: Before adjusting any kind of the
features this appliance includes, switch off the
appliance, turn off the water supply and discon-
nect the appliance from the mains.
ADJUSTING THE WATER JET OUTLET
- The angle of spray coming out the appliance
can be adjusted by rotating the nozzle. This
will vary the spray patter approximately from a
narrow stream (high impact) to a 60º wide fan
spray.
CLEANING THE NOZZLE
- To clean the nozzle, use the Tip cleaner (M) on
the nozzle water outlet, so you will have to in-
troduce the cleaning tip and move during 50-60
seconds in order to erase any water disturbance
on the nozzle.
DETERGENT APPLICATION
JHB70, JHP14, JHP16
- In order to use the detergent function, take the
soap bottle out of the soap nozzle and fill it with
an adequate cleaning product, suitable for this
kind of products. Connect again the soap bottle
to the soap nozzle (Fig. 6).
- After you used all the detergent in the bottle,
refill it or replace it for the lance in order to finish
cleaning task.
- WARNING: this appliance constantly takes the
soap. If you are using the appliance with deter-
gent and you want to stop using detergent but
continue cleaning, take out the detergent tube,
placed in the soap tank.