Casals JHB70 Manual Del Usuario página 18

- Dismount the unit following the steps on moun-
ting but afterwards.
- Ensure cables are not trapped when stroing.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
If any anomaly is detected, check the following table.
Units with tanks
No deter-
gent suction
Units with
attachable
applicators
Pressure washer does not
start up
Pump does not reach the
necessary pressure
Fluctuating pressure
or repair the appliance yourself as this may be
dangerous.
- If the connection to the mains has been dam-
aged, it must be replaced, take the appliance to
an authorised technical support service. Do not
attempt to disassemble or repair the appliance
by yourself in order to avoid a hazard.
Lance nozzle is not in ow
pressure mode
High pressure extension
hose or high pressure hose is
too long
Injector is clogged on pump
Detergent applicator is
clogged
Unit is pressurized
Plug is not well connected or
electric socket is faulty
Extension cord is too long or
wire size too small
Main voltage supply is too
low
Thermal safety switch has
tripped
Water inlet filter is clogged
Pump is sucking air from
hose connections
Nozzle is worn or not correct
Unloader is clogged or worn
Valves are clogged or worn
Pump is sucking air from
hose connections
Clogged nozzle
Valves are dirty, worn or
stuck
Water seals worn
Slide lance nozzle into low pressu-
re position
Remove high pressure extension
hose shorter than 7,5 m
Bring the appliance to any custo-
mer serrvice
Clean applicator with warm water.
If it not works, replace the appli-
cator
Squeeze trigger on gun
Check plug, pocket and fuse
Remove extension cord
Check the voltage in the main
supply match the voltage indicated
on the Rating Label
Switch off unit and allow motor to
cool down
Clean water inlet filter
Check that connections and loc-
king ring are properly tightened
Bring the appliance to any custo-
mer service
Check that connections and loc-
king ring are properly tightened
Clean the nozzle with the typ
cleaner.
Bring the appliance to any custo-
mer service